sise 300-715

sise 300-715

• 3047 Reviews

All switches must be configured with the same VTP domain name if they are to exchange VLAN information, as illustrated in the output below: 1 000c.cea7.f3a0 SecureSticky Gi0/2 - 1 0013.1986.0a20 SecureSticky Gi0/2 - 1 001d.09d4.0238 SecureSticky Gi0/2 - Routing for Networks: Secure Mac Address Table R1(config-if)#ipv6 add 2001:aaaa:bbbb:cccc::1/64 R1(config-if)#no shut The following output illustrates how to configure dynamic sticky learning on a port and restrict the port to dynamically learn up to a maximum of 10 MAC addresses: We will cover how to disable CDP on the device or interface only in the lab. Two other commands are show cdp, which displays protocol information for the device, and show cdp entry , which shows information about a specific device by inputting the name. I recommend that you spend some time checking CDP outputs during the labs you will configure in this guide. Day 11 Labs Day 7 Lab 11voice active ---- ----------- ---- ----- ------------ 　　Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Automatic network summarization is not in effect Entry address(es): Copyright (c) 1986-2005 by Cisco Systems, Inc. Compiled Wed 12-Oct-05 22:05 by pt_team In DHCP, there is a special field available that helps extend the capabilities of this automatic configuration process. You can put many different configuration options inside this field, which are also present in the DHCP RFC. Verifying That the Routing Table Is Valid Configuring a switchport to support IP phones is not as complex as you may think once you understand the full capabilities of what an access port can do. For example, even though a port connected to a phone acts like an access port, the voice frames are tagged with an 802.1Q header so that the switch and the phone will understand what is voice traffic versus data traffic. 3.Check the LLDP entry for Switch1, note that LLDP is disabled and then enable it on both sides. Physical media capabilities - not advertised Media Attachment Unit type - not advertised Vlan ID: - not advertised In Figure 9.2, the switch is operating normally and, based on the CAM table entries, knows the MAC addresses for all the devices connected to its ports. Based on the current CAM table, if Host 4 wanted to send a frame to Host 2,sise 300-715, the switch would simply forward the frame out of its FastEthernet0/2 interface toward Host 2. Unlike Distance Vector routing protocols, which send their neighbors their entire routing table, Link State routing protocols send incremental updates when a change in the network topology is detected, which makes them more Rapid convergence line vty 0 15 Today you will learn about the following: Chassis id: 0200.2222.2222 Port id: Gi0/1 % LLDP is not enabled Switch#conf t Switch(config)#lldp run 5.Issue the show line command and note how many vty lines you have. Then issue a username and password to be entered by users telnetting in. The first line in bold text is confusing, as it shows that the VTP version is VTP version 2. However, this line simply indicates that this switch is version 2-capable. To determine whether VTP version 2 is enabled, the VTP V2 Mode line should be referred to. In the output printed above, this shows ‘Disabled’, meaning that even though the switch is version 2-capable, as is stated in the first line, it is still running the default version (1) and version 2 is disabled.

Free Download Dumps Demo & Study Tools

Latest CCNP Security 300-715 SISE Dumps

100% guarantee you pass the CCNP 300-715 exam! Are you still confused about the exam? Don't worry！You have already take the first step to success. Just choose us without any worries!