350-601 dccor cisco press

350-601 dccor cisco press

Router(config)#access-list 1 permit host 172.16.1.1 Switch-1(config-if)#switchport mode access 3.1Describe the routing concepts The default route source administrative distance is displayed in the output of the show ip protocols command. This is illustrated in the following output: Total Addresses in System : 5 Security Violation Count 1 via ::, FastEthernet0/0 Switch#show vtp status VTP Version 2 IP Addressing and Address Summarization The device moves to another subnet (e.g, to a wireless network from a wired network) 3.2Interpret the components of routing table Routing Information Sources: 6.3 below: The following are examples of problems and possible solutions: Trunk down? Gateway of last resort is not set 3.7 Configure, verify,350-601 dccor cisco press, and troubleshoot RIPv2 for IPv4 (excluding authentication, filtering, manual summarization, redistribution) In addition to using the show ipv6 route command, the show ipv6 static [prefix] [detail] command can also be used to view detailed information about all or just specified static routes. The following output illustrates how to use this command: 13. The starting and ending points of the vector are not relevant. Instead, the only thing that actually matters is how long the vector is and how far it travels. Device ID: Router1 Entry address(es): Subnet Mask. : 255.255.0.0 ! Challenge 4 – LLDP Lab 5.Issue the show line command and note how many vty lines you have. Then issue a username and password to be entered by users telnetting in. Routing Information Sources: Gateway of last resort is not set 172.16.0.0/24 is subnetted, 1 subnets MAC Spoofing Attacks You may be asked to explain what happens with a packet received from one network and destined for another network. Firstly, the router decapsulates the Layer 3 packet by removing the Layer 2 frame header and trailer. Next, it examines the destination IP address of the IP packet to find the best path in the routing table. Finally, it encapsulates the Layer 3 packet into a new Layer 2 frame and forwards the frame out of the exit interface, so the encapsulation could change from Ethernet to HDLC. This is illustrated in Figure 10.