cisco 350-801 exam

cisco 350-801 exam

prompt-timeout Set Message for login authentication timeout slip-ppp Set Message for SLIP/PPP access-list 101 deny tcp 10.1.0.0 0.0.255.255 host 172.30.1.1 eq telnet Vlan Mac Address Type Ports Remaining Age Switch#configure terminal Switch(config)#interface GigabitEthernet1/1 Switch(config-if)#lldp transmit Switch(config-if)#lldp receive Switch(config-if)#end SSH Enabled - version 1.99 Some engineers become confused when their ACL doesn’t perform as expected. The router will look at the top line of the ACL, and if it sees a match, it will stop there and will not examine the other lines. For this reason, you need to put the most specific entries at the top of the ACL. For example, take the ACL blocking host 172.16.1.1: Walkthrough The switch must be running CDP in order to identify the connected device as an IP phone. S 10.0.0.0 is directly connected, Serial0/1/0 Routing Information Sources: labels Display labels for IPv4 NLRI specific information Configuring Access Control Lists R1#show ip route 80.1.1.1 Routing entry for 80.1.1.0/24 Switch1(config)#lldp run Switch#show port-security int FastEthernet0/1 Port Security : Enabled CAM table attacks are easy to perform because common tools, such as MACOF and DSNIFF, are readily available to perform these activities. While increasing the number of VLANs (which reduces the size of Broadcast Domains) can assist in reducing the effects of CAM table attacks, the recommended security solution is to configure the port security feature on the switch. Neighbor address 2: 000000000000 Total MAC Addresses 1 Set a VTP Password Compiled Wed 18-Jul-07 04:52 by pt_team advertisement version: 2 R1(config)#ipv6 route ::/0 f0/0 FE80::C004:8FF:FE2F:0 ACL Basics Change the Management VLAN 　　Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Switchport: Enabled Administrative Mode: trunk Operational Mode: trunk To see the actual configured static secure MAC address on the port, the show port-security address or the show running-config interface [name] command must be used. The following output illustrates the show port-security address command: Another important detail that is offered by the show interface trunk command is the trunk status. This confirms whether the trunk is formed or not and it has to be checked at both ends of the link. If the interface is not in “trunking” mode, one of the most important things that has to be verified is the mode of operation (on, auto,cisco 350-801 exam, etc.) to see whether it will allow a trunking state to form with the other end of the link.