spoto ccie r&

spoto ccie r&

• 1835 Reviews

CDP is a hot exam topic because it provides a means to discover information about network devices before any configuration has been applied. This is a very useful troubleshooting tool; however, it also presents a security risk. 1.Stop ACL traffic on the interface with the no ip access-group 99 in command. Switch-1(config-if)#switchport trunk native vlan 30 Switch-1(config-if)#exit Troubleshooting Trunking and VTP 2.7.bDynamic compress-config Compress the configuration file config TFTP load config files R1(config-if)#router rip 1 001f.3c59.d63b SecureConfigured Gi0/2 - The same command are discussed more than once in this chapter. Firstly by myself but then in a different context by one of our CCIE authors. I decided to do it this way so you can see another perspective. R2(config)#router rip ACL Rule 4 – The router can’t filter self-generated traffic. Counting to infinity Split horizon Poison reverse Hold-down timers Switch(config-if)#switchport trunk native vlan 888 4.Issue a show privilege command and note the default level for users (covered later) Command rejected: Conflict between ‘nonegotiate’ and ‘dynamic’ status. Switch(config-if)#switchport mode trunk Pinging 192.168.1.1 with 32 bytes of data: 4.Set the hosts ports on the switches to access ports. Router(config-subif)#int g0/1.20 Router(config-subif)#encap dot Aging Time : 0 mins R2#ping 2001:aaaa:bbbb:cccc::1 password-encryption Encrypt system passwords password-recovery Disable password recovery prompt Enable mode specific prompt 3.Set all passwords to be encrypted with level 7 encryption. exec-wait Delay EXEC startup on noisy lines finger Allow responses to finger requests 2 0013.1986.0a20 DYNAMIC Fa0/2 Codes: C - connected, S - static, I - IGRP,spoto ccie r&, R - RIP, M - mobile, B – BGP, D - EIGRP, EX - EIGRP external, O - OSPF, Configure different port speeds/auto-negotiation on various switch ports Verify the port parameters with the show run and the show interface commands Total entries displayed: 1 Switch#Name: Gig0/1 Verifying that the end-stations are connected in the proper switch ports Verifying that the proper switch ports are connected in the proper router ports (if a router is used for inter-VLAN routing) Port Vlans in spanning tree forwarding state and not pruned Fa0/6 10, 20 Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP U - Per-user static route 5.Your IT manager changes his mind and wants only SSH access, so change this on your VTY lines. Only certain models and IOS versions will support the SSH command. interface GigabitEthernet0/2 switchport Port Description: GigabitEthernet0/1 System Name: Switch1 R1(config-router)#network 172.16.0.0 4.3Configure and verify DHCP on a router (excluding static reservations) DNS Servers. : 0.0.0.0 network 12.12.12.0 This configuration can be validated via the show interfaces [name] switchport command, as illustrated in the following output: 192.168.1.0 Instructions Day 11 Tasks dynamic Set trunking mode to dynamically negotiate access or trunk mode trunk Set trunking mode to TRUNK unconditionally Shutdown VLAN (outside of the CCNA syllabus) R 192.168.1.0/24 [120/1] via 172.16.1.1, 00:00:40, FE0/0 Aging type : Absolute Request timed out. R1(config-router)#no auto-summary Switching Concepts Success rate is 80 percent (4/5), round-trip min/avg/max = 31/31/32 ms Switch# RouterA#ping 10.1.1.1 Invalid after 0 seconds, hold down 0, flushed after 0 Outgoing update filter list for all interfaces is not set Incoming update filter list for all interfaces is not set Redistributing: isis 14.3below: Server life time-out: 180 seconds Administrative distance is used to determine the reliability of one source of routing information from another. Some sources are considered more reliable than others are; therefore, administrative distance can be used to determine the best or preferred path to a destination network or network node when there are two or more different paths to the same destination from two or more different routing protocols.

Free Download Dumps Demo & Study Tools

Latest CCNP Enterprise 350-401 ENCOR Dumps

If you want to pass the first exam successfully, the next you must take a serious look! All of our dumps are verified by IT certified experts. Our Cisco 350-401 ENCOR  CCNP Enterprise Dumps contains all the real topics of the day. What is our goal? To help you pass the exam successfully! You can trust us completely, and we will definitely not let you down. You can find us at anytime because we are willing to serve you guys !

Come on! Do your wisely decision!