dinli 350 dl 801

dinli 350 dl 801

Change the Management VLAN traffic CDP statistics vrf Select a VPN routing/forwarding instance 5.Now add a static default route on R1 to send any traffic for any Read today’s lesson notes (below) Complete today’s lab Default gateway (router): 192.168.1.1 DNS server: 8.8.8.8 Switchport: Enabled Administrative Mode: static access Operational Mode: static access Now please take today’s exam at 6.Add a SVI to VLAN1 and then telnet to the switch using that IP address to test the username and password. %LINK-5-CHANGED: Interface Vlan3, changed state to up Switch(config-if)#ip address 192.168.1.1 255.255.255.0 The third packet is the DHCP Request: RouterB#show ip route 172.16.1.1 Routing entry for 172.16.1.0/24 Day 14 Labs Switch(config)# Total entries displayed: 1 Cisco created CDP to address an issue left unresolved by any open standard protocol. Eventually, a standard protocol was released, defined by IEEE standard 802.1AB, and it’s called Link Layer Discovery Protocol (LLDP). LLDP provides many of the same features as CDP but the similarities don’t end there, because LLDP shares many of the same configurations and show commands as CDP. 6.Wait about 30 seconds at most and then ping from PC to PC. 4.Issue a show ip route and check all networks on both routers old-slip-prompts Allow old scripts to operate with slip/ppp pad Enable PAD commands This can cause confusion when doing testing before implementing your ACL on a live network. A router won’t filter traffic it generated itself. This is demonstrated in Figure 15.2 below: 04:23:31: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation occurred, caused by MAC address 000c.cea7.f3a0 on port Gi0/2. Packet forwarding involves two processes: Determining the best path Switch(config-if)#switchport trunk encapsulation dot1q Switch(config-if)#switchport mode trunk Switch(config-if)#switchport nonegotiate Switch(config-if)#exit Renewal (T1) timer (default 50% of the lease time): Whenever a workstation obtains an IP address, this timer starts up, and when 50% of the lease time has been reached, the DHCP client will try to renew its lease with the original DHCP server. Along with subnetting and VLSM, access control lists (ACLs) are one of the bugbear subjects for new Cisco students. Among the problems are learning the IOS configuration commands, understanding ACL rules (including the implicit “deny all” rule), and learning the port numbers and protocol types. Device ID Local Intrfce Holdtme Capability Platform Port ID IP Phone Fas 0/1 147 H P 7960 Switch-1(config-if)#switchport port-security mac-address 001f.3c59.d63b vlan 5 Passive Interface(s): R2(config-if)#ipv6 address 2001:aaaa:bbbb:cccc::2/64 R2(config-if)#no shut this to indicate that a route is no longer reachable. This is accomplished by setting the route metric to a maximum value. As seen in the output above, by default, only a single secure MAC address is permitted per port. In addition,dinli 350 dl 801, the default action in the event of a violation is to shut down the port. The text in bold indicates that only a single secured address is known, which is the static address configured on the interface.