cisco 350-801 training

cisco 350-801 training

1.Add IP addresses for hosts inside the respective VLANs. 5.Change the MAC address of the PC or plug in another machine. trunk link because routers don’t support DTP. If the trunk is configured as an 802.1Q trunk, a native VLAN must be defined if a VLAN other than the default will be used as the native VLAN. This native VLAN must also be configured on the respective router subinterface using the encapsulation dot1Q [vlan] native subinterface configuration command. i - IS-IS,cisco 350-801 training, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area The commands above may not work if you are using Packet Tracer. Also, please do try these commands on a router because they are exam topics. Bear in mind that you should disable the ACL on the interface (so it’s no longer live) before you edit it in order to avoid strange or unpredictable behavior. I’ll show you how to edit live ACLs on IOS 12.4 and later shortly. Building the IP Routing Table 3.Add a static route exit interface on the hub router for 10.1.1.0/20 subnet Vlan Mac Address Type Ports R2(config)#int f0/0 exec-wait Delay EXEC startup on noisy lines finger Allow responses to finger requests Day 14 Tasks Router0# Some important considerations for static default routing: You need to enter a wildcard mask if you want your ACL to match a subnet or an entire network. For example, if you wanted to match 172.20.1.0 255.255.224.0, you would enter the following: Banner messages can be: The go-to command for all routing information is show ip protocols. Take the time to read the outputs when you configure any routing labs. ipv4 Address family Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(25)FX, RELEASE SOFTWARE (fc1) WORD VLAN IDs of the allowed VLANs when this port is in trunking mode add add VLANs to the current list command won’t be accepted while the port is set to dynamic. Access Mode VLAN: 10 (data) Trunking Native Mode VLAN: 1 (default) Voice VLAN: 11 Switchport: Enabled Administrative Mode: trunk Operational Mode: trunk 7.Disable DTP on the right switch and set interface to trunk. Issue a show interface trunk command on either switch. Generally speaking, the most common services to enable/disable are listed below with their descriptions in Table 9.1: Spend 15 minutes on the subnetting.org website A “network” as it applies to network routing is a remote subnet that you would like to reach. Some examples may be 10.1.0.0/24, 192.168.0.0/16, or 38.122.188.0/25. Basically, if it’s anything below a /31 subnet, then you ultimately would need to rely on a network route to reach it. When configuring routing on your network devices, you have to carefully configure static or dynamic routing based on the design. If you have a problem and are not able to send/receive traffic across the network, then you probably have some kind of configuration issue. When you initially set up a router there will most likely be some type of configuration problem that you will have to troubleshoot. If the router has been running for a while and you suddenly have a complete failure of traffic (no communication), you should analyze the situation and figure out whether the routing protocol functions as expected.