cisco 350-801 dumps

cisco 350-801 dumps

All switches must be configured with the same VTP domain name if they are to exchange VLAN information, as illustrated in the output below: Switch-1(config-if-range)#switchport access vlan 10 Switch-1(config-if-range)#switchport mode access Switch-1(config-if-range)#exit This packet is sourced by the DHCP server and broadcasted on the network; it also contains some extra fields as seen in the Figure 14.8 above: Configure a port as a trunk (802.1Q) and assign VLANs to the trunk Verify VLAN configuration using the show vlan command Configuring Sticky Secure MAC Addresses show vtp status / show vtp password Pinging 192.168.1.1 with 32 bytes of data: Subnet Mask. : 255.255.0.0 Topology Troubleshooting RIP Configure a port as a trunk (802.1Q) and assign VLANs to the trunk Verify VLAN configuration using the show vlan command Purpose R2#ping 2001:aaaa:bbbb:dddd::1 Type escape sequence to abort. IPv6 Static Routes 8 0030.803f.ea82 DYNAMIC Fa0/6 Router(config)#ip dhcp pool passhot Router(dhcp-config)#default-router 172.16.1.2 Gateway Distance Last Update 10.0.0.2 115 00:06:53 2.If the route entry is more specific than an existing route, add it to the routing table. It should also be noted that the less specific entry is still retained in the routing table. Router0#show cdp neighbors detail Device ID: Switch0 The commands above may not work if you are using Packet Tracer. Also, please do try these commands on a router because they are exam topics. Bear in mind that you should disable the ACL on the interface (so it’s no longer live) before you edit it in order to avoid strange or unpredictable behavior. I’ll show you how to edit live ACLs on IOS 12.4 and later shortly. Read today’s lesson notes (below) Review yesterday’s lesson notes and lab Complete today’s lab Switch#show int g0/1 switchport Name: Gig0/1 Switch-1(config-if-range)#switchport access vlan 10 Switch-1(config-if-range)#switchport mode access Switch-1(config-if-range)#exit Link State Routing Protocols In the output above, the text in bold indicates that despite the static configuration of the trunk link,cisco 350-801 dumps, the port is still sending out DTP and DISL packets. In some cases, this is considered undesirable.