ccnp 350-601

ccnp 350-601

Other types of tools you can use are standard ping and traceroute utilities in order to verify end-to-end connectivity. They can also show relevant output From a programming perspective, here is how it looks. First, make sure that you load balance 192.168.1.0/24 over both circuits. WORD VLAN IDs of the allowed VLANs when this port is in trunking mode add add VLANs to the current list unicast-flood Disabled 1003 token-ring-default active ! 3.If the route entry is the same as an existing one, but it is received from a more preferred route source, replace the old entry with the new entry. Router(config)#access-list 1 permit host 172.16.1.1 4.If the route entry is the same as an existing one, and it is received from the same protocol, then: 192.168.1.0 Inter-VLAN Router Subinterfaces Lab As with CDP,ccnp 350-601, leaving LLDP turned on while on any edge devices represents a security risk. We will cover this in the security notes (and the following lab). Enter configuration commands, one per line. End with CTRL/Z. R1(config)#ip route 0.0.0.0 0.0.0.0 170.170.3.4 pagp-flap Disabled port-mode-failure Disabled Access Mode VLAN: 1 (default) Trunking Native Mode VLAN: 1 (default) ---------- Switch-1(config-if)#switchport mode access Switch-1(config-if)#switchport port-security Ping statistics for 10.10.10.254: Create a series of VLANs on the server switch and see how they propagate to each other To turn off CDP for a particular interface, issue the following command: After this is implemented, you start getting calls from your end-users saying 7.Recover by adding the correct MAC address to the PC and resetting the interface with a shut and no shut command. Connect three routers together with serial or ethernet connections 1004 fddinet-default active Extended ACLs You will actually learn much more about troubleshooting RIP when you get to the configuration labs. network 11.11.11.0 If you look back at the administrative distances table in Day 10, you will see <1-65535> Process ID number Accurate monitoring and reporting of VLANs VLAN consistency across the network Default version control: send version 2, receive version 2 Interface Send Recv Triggered RIP Key-chain FastEthernet0/0 2 2 Switch(config)#vtp password Cisco321 VLAN information not passing? Review previous lessons and labs from day 9-12 Read the ICND1 cram guide Loopback0 2 2 You can also implement this route using the router’s outgoing interface instead of the next hop. So, for example, if Router 1 uses Ethernet 0/2 to connect to Router 2, it would look like this: Violation Mode : Shutdown Gateway of last resort is 170.170.3.4 to network 0.0.0.0. Router#show ip bgp ? Router#show ip interface brief Generally speaking, the most common services to enable/disable are listed below with their descriptions in Table 9.1: Without a populated routing table, or Routing Information Base (RIB), that contains entries for remote networks, routers will not be able to forward packets to those remote networks. The routing table may include specific network entries or simply a single default route. The information in the routing table is used by the forwarding process to forward traffic to the destination network or host. The routing table itself does not actually forward traffic.