ccnp 350-501

ccnp 350-501

Read today’s lesson notes (below) Review yesterday’s lesson notes and labs Complete today’s labs Subnet mask: 255.255.255.0 Switch# R1(config)#interface FastEthernet0/0.30 3.Assign a static route on Router A, sending all traffic for the 10.1.1.0/10 network out of the Serial interface. Use your own serial number,ccnp 350-501, of course; don’t just copy mine if yours has a different number! I’ve not added the interface configs because you already know how. 1.Connect a PC or laptop to your switch. In addition, set up a console connection for your configuration. The port to which you connect your PC will be the one you configure security settings on in this lab. I have chosen FastEthernet 0/1 on my switch. 3.Add a static route exit interface on the hub router for 10.1.1.0/20 subnet dot1q - Interface uses only 802.1q trunking encapsulation when trunking via ::, FastEthernet0/0 Port Vlans allowed and active in management domain Fa0/6 10, 20 Switch#show cdp neighbors detail Device ID: Switch 01:29:15: RIP: received v2 update from 172.16.1.2 on Serial0 01:29:15:192.168.2.0/24 via 0.0.0.0 Review previous lessons and labs from day 9-12 Read the ICND1 cram guide The switching process allows the router to accept the packet via one interface and send it out of another. The router will also encapsulate the packet in the appropriate Data Link frame for the outgoing link. Bindings from all pools not associated with VRF: The first step is enabling the DHCP service on the router. This is done using the service dhcp command, as exemplified below: For success in the CCNA exam, and to make it as a new Cisco engineer, you need to understand the following: CRC or other types of errors on device interfaces Routing table information Switch#sh version Let’s implement two different routes into the routing table using each method and see if you can discern the different behavior in the routing table. Total entries displayed: 1 Switch#show lldp neighbors detail If you can’t ping across a directly-connected link, then you need to fix that issue before checking for routing issues. Next, check your routing configuration. You need to ensure that there are no unwanted passive Router(config)#access-list 1 permit host 172.16.1.1 Today you will learn about the following: RIP SwitchA(config)#vlan 2 SwitchA(config-vlan)#name passhot Walkthrough Day 7 – CDP and LLDP Please take the day 5 exam at I’ve already mentioned that you can actually have both a password and an enable secret password on your router and switch, but this can cause confusion. Just set the enable secret password. The configuration file below illustrates how to issue a command without dropping back to Privileged mode by typing do before the command: 13. The starting and ending points of the vector are not relevant. Instead, the only thing that actually matters is how long the vector is and how far it travels. 1 0004.c16f.8741 SecureSticky Gi0/2 - However, it is important to remember that the native VLAN must be the same on both sides of the trunk link. If there is a native VLAN mismatch, Spanning Tree Protocol (STP) places the port in a port VLAN ID (PVID) inconsistent state and will not forward traffic on the link. Additionally, CDPv2 passes native VLAN information between switches and will print error messages on the switch console if there is a native VLAN mismatch. The default native VLAN can be changed by issuing the switchport trunk native vlan [number] interface configuration command on the desired 802.