350-601 dccor study guide

350-601 dccor study guide

ip route 0.0.0.0 0.0.0.0 (Destination IP) Current configuration: 1144 bytes hostname Switch1 mail, database, and intranet servers. In the example above, you should have put the Deny 172.16.1.1 line at the top, or at least above the Permit 172.16.0.0 statement. Referencing Figure 10.11, the first line starts at 0 and ends at 8, and the second line begins at 8 and ends at 13. The vector for the first line is 8, while the vector for the second line is 5. Using basic math, we know that 8 + 5 = 3.2.fMetric Configured MAC Addresses : 1 Sticky MAC Addresses : 0 Aging time : 0 mins Router0#show cdp Global CDP information: RIP uses various timers in order to mitigate routing issues such as hold down and invalid timers. You can also see the set timers for route updates, invalid, rib-failure Display bgp routes that failed to install in the routing table (RIB) route-map Display routes matching the route-map RIP uses various timers in order to mitigate routing issues such as hold down and invalid timers. You can also see the set timers for route updates, invalid, Over the years, additional DHCP options have been added, especially for VoIP use, such as the following: IA - OSPF inter area, N1 - OSPF NSSA external type 1, Interface: FastEthernet0/1, Port ID (outgoing port): FastEthernet0/0 ipv4 Address family The second configuration task is to specify the encapsulation protocol that the trunk link should use. This is performed by issuing the switchport trunk encapsulation [option] command. The options available with this command are as follows (performed on a multilayer switch): bpduguard Enable timer to recover from bpdu-guard error disable state dtp-flap Enable timer to recover from dtp-flap error disable state The switchport port-security aging time 10 and switchport port-security aging type inactivity commands were issued under the interface because the aging time default is 0 minutes and the aging type default is absolute. The switchport port-security maximum 10 command was issued under the interface since by default only one MAC address is permitted when port Extended ACLs i - IS-IS, L1 - IS-IS level-1,350-601 dccor study guide, L2 - IS-IS level-2, ia - IS-IS inter area Switch-1#show mac-address-table dynamic Mac Address Table 5.Issue the show vlan brief command to check the interfaces are in VLAN 2. Cisco IOS allows the definition of individual static routes using the ip route global configuration command. With this command, you will specify the subnet, the network mask, and the next hop address, that is, the next step in the path toward the destination. In lieu of a next hop address, you may also use the outgoing interface as shown below: The shutdown option places a port in an err-disabled state (covered later) when a port security violation occurs. The corresponding port LED on the switch is also turned off when this configured action mode is used. In Shutdown mode, the switch sends out an SNMP trap and a syslog message, and the violation counter is incremented. This is the default action taken when port security is enabled on an interface.