350-501 spcor ine

350-501 spcor ine

Switch-1(config)#interface FastEthernet0/1 RIP is now back in the syllabus but it only specifies version 2. I’ve outlined the original version so you can see the differences as well as understand how classful protocols operate. Day 11 Labs R1(config-subitf)#description ‘Subinterface For VLAN 20’ R1(config-subif)#encapsulation dot1Q 20 [Output Truncated] When I Telnet to the switch from my router, I can see the banner message. The mistake was choosing Y as the delimiting character because it cuts off my message: R 80.1.1.0/24 [120/1] via 10.1.1.2, 00:00:04, Ethernet0/0.1 　remove remove VLANs from the current list Switch1(config-if)#switchport trunk allowed vlan 7-12 I’ve seen this often on live networks. You will usually have the same ACL policy throughout your network. Rather than configuring several ACLs, simply refer to the same ACL and apply it to as many interfaces as you require. Figure 15.3 below illustrates this concept: So, why would you want to use host routes? There may be times when you have a redundant path to a host and you only want traffic to that host flowing over one path. In Figure 11.8 below, a branch office needs to communicate with a latency-sensitive application hosted on a server with the IP address A banner message will show when a user logs in to your router or switch. It won’t offer any actual security but it will display a warning message of your choice. In the configuration below, I chose the letter Y as my delimiting character, which tells the router that I’ve finished typing my message: Most RIP issues are related to the administrator mistyping commands or misunderstanding VLSM. We will cover IP troubleshooting later on, but double-check that your router interfaces are up (physically and logically). Check that your IP address and subnet mask are correct as well. Administrative Trunking Encapsulation: dot1q Operational Trunking Encapsulation: dot1q Negotiation of Trunking: On Gateway Distance Last Update 10.0.0.2 115 00:06:53 Cisco IOS Software, 1841 Software (C1841-ADVIPSERVICESK9-M),350-501 spcor ine, Version 12.4(15)T1, RELEASE SOFTWARE (fc2) RIP Passive Interfaces In the design, the network uses Open Shortest Path First version 2 (OSPFv2) over the primary link, learning the routes to the core dynamically. The Branch Router also defines static routes to the core over the backup link for the exact same subnets. Remember, static routes have an administrative distance of 1 and OSPF routes have an administrative distance of 110.