350-501 spcor dump

350-501 spcor dump

! Cisco routers use the administrative distance, the routing protocol metric, and the prefix length to determine which routes will actually be placed into the routing table, which allows the router to build the routing table. The routing table is built via the following general steps: R2#ping 2001:aaaa:bbbb:cccc::1 RouterA#show ip route Chassis id: 0001.64EE.CB19 Port id: Gig0/1 Path Length Switch(config)#interface FastEthernet0/1 Switch(config-if)#switchport port-security Gateway of last resort is 170.170.3.4 to network 0.0.0.0. R2 Fa0/13 91 R Gi0/1 1.If the route entry does not currently exist in the routing table, add it to the routing table. 　Gateway Distance Last Update Distance: (default is 120) L1 - IS-IS level-1, L2 - IS-IS level-2, Split horizon: Split horizon prevents updates from being sent out of the same interface they came from because routers in that area should already know about that specific update. Floating Static Routes i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area Duplex: full Router# SwitchA#show vlan brief The following configuration outputs correspond to Figure 7.1: Day 10 Tasks 3.Put two fast Ethernet interfaces into VLAN2 for the hosts and add IP R1#show ip route static Packets: Sent = 2, Received = 0, Lost = 2 (100% loss) 04:23:31: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation occurred,350-501 spcor dump, caused by MAC address 000c.cea7.f3a0 on port Gi0/2. There are two major classes of routing protocols – Distance Vector The interface is up, and the switchport port-security command was issued under the interface. This is reflected in the Secure-up port status. Switch#show interfaces FastEthernet0/1 switchport Name: Fa0/1 Take off the active interface: Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP You can verify a port is in the shutdown state in multiple ways, one of which is using the show ip interface brief command: Now please take today’s exam at arp-inspection Disabled As you can see in Figure 11.10 above, the OSPF route is now preferred, but should OSPF indicate that the path is no longer valid through Low Latency Networks (possibly because of an interface or service provider failure), then the backup path using static routes over T1 will be used. 1default active Fa0/2, Fa0/3, Fa0/4, Fa0/5, If Serial 0/0/1 went down due to a link failure, the static route would no 　Gateway Distance Last Update Distance: (default is 120) 1default active Fa0/2, Fa0/3, Fa0/4, Fa0/5, C 170.170.3.0 is directly connected, Ethernet0 Different tools can be used to monitor network devices. A common network management protocol used by these tools is Simple Network Management Protocol (SNMP), which was designed to query network devices for different parameters from a management station (SNMP is covered in ICND2). Besides the standard “health” parameters checked (e.g., CPU, memory, disk space, etc.