350-501 spcor cisco press

350-501 spcor cisco press

R1(config)#ip route 192.168.1.0 255.255.255.0 10.0.0.1 250 Port Mode Encapsulation Status Native vlan Fa0/6 off 802.1q not-trunking 1 From a programming perspective, here is how it looks. First, make sure that you load balance 192.168.1.0/24 over both circuits. Configuring DHCP Cisco has excluded the advanced features of RIP, such as authentication and redistribution, from the syllabus so we won’t go into them here. I’ve seen this often on live networks. You will usually have the same ACL policy throughout your network. Rather than configuring several ACLs,350-501 spcor cisco press, simply refer to the same ACL and apply it to as many interfaces as you require. Figure 15.3 below illustrates this concept: ------------------------------------------- Static allocation of IP addresses by a DHCP server implies defining the MAC addresses that you expect to see on the network and manually assigning a unique IP address for each of them, thus administratively building a MAC-to- IP association table. This is commonly used in a server environment because servers must use predictable IP addresses in order to be accessed. Day 6 Tasks Walkthrough * - candidate default, U - per-user static route, o - ODR, P - periodic downloaded static route Total MAC Addresses 0 Switch#show interfaces trunk On the switch, the single link connected to the router must be configured as a 192.168.1.4/30 This would be applied to the server side router. Remember that there will be an implicit “deny all” at the end of this list, so all other traffic will be blocked. 3.On the left router turn LLDP off the interface. 14.3below: DHCP Functionality DHCP Operations Static Default Routes Aging Time : 0 mins The Objectives of Routing Protocols The first step in troubleshooting routing is verifying that the routing protocol is enabled and properly configured. This can be done either by inspecting the current running configuration (i.e., the show run command) or by using show commands associated with each particular routing protocol. Some of these options are listed below: Gateway Distance Last Update 10.0.0.2 115 00:06:53 Please log on to a Cisco switch and enter the commands explained in this module. This should include: Sometimes certain routes might intermittently disappear and appear from the routing table, causing intermittent connectivity to specific destinations. This may be because a certain network area has some kind of communication problem and routers along the path propagate new routing information every time that area becomes accessible. This process is called “route flapping,” and the specific routes can be blocked so the entire network is not affected using a feature called “route dampening.