350-501 spcor

350-501 spcor

Enter TEXT message. End with the character ‘Y’. KEEP OUT OR YOU WILL REGRET IT Y Default version control: send version 2, receive version 2 Interface Send Recv Triggered RIP Key-chain FastEthernet0/0 2 2 Max Addresses limit in System : 1024 .!!!! You should always disable the services you are not going to use. Cisco has done a good job by not enabling insecure or rarely used services/protocols by * - candidate default, U - per-user static route, o - ODR, P - periodic downloaded static route Always add a new switch in Client mode (but check the above note on the configuration revision number) psecure-violation security-violation storm-control udld Router(config)#access-list 1 permit 172.16.2.1 Router(config)#interface FastEthernet0/0 Router(config-if)#ip access-group 1 in Day 15 Tasks In the previous module, you learned that 802.1Q, or VLAN tagging, inserts a tag into all frames, except those in the native VLAN. The IEEE defined the native VLAN to provide for connectivity to old 802.3 ports that did not understand VLAN tags. 4.DHCP ACK packet: The DHCP server sends another broadcast message to confirm the IP address allocation to that specific client,350-501 spcor, again using UDP source port bootps 67 and destination port bootpc 68. Switch-1(config)#interface GigabitEthernet0/2 Switch-1(config-if)#switchport Rapid convergence Routing Information Sources: database RIP database events events RIP protocol events trigger RIP trigger extension 2.Ping across the Serial link to ensure that it is working. This module maps to the following CCNA syllabus requirements: show ip route show ip route rip show ip protocols Total entries displayed: 2 SW2#show lldp entry R2 link-flap Enable timer to recover from link-flap error disable state pagp-flap Enable timer to recover from pagp-flap error disable state rootguard Enable timer to recover from root-guard error disable state udld Enable timer to recover from udld error disable state Unused or “empty” ports within any network device pose a security risk, as someone might plug a cable into them and connect an unauthorized device to the network. This can lead to a number of issues, including: Total Addresses in System : 2 From a network administrator’s point of view, it is important to understand that the bandwidth command does not affect the physical capability of the interface (so it is sometimes referred to as a cosmetic command). In other words, configuring the higher bandwidth on the FastEthernet interface does not mean that it is capable of supporting GigabitEthernet speeds. Open Shortest Path First (OSPF) and Enhanced Interior Gateway Routing Protocol (EIGRP) use bandwidth in metric calculations.