300-815 claim

300-815 claim

S 3FFF:1234:ABCD:1::/64 [1/0] 4.Test Telnet by Telnetting from your PC to your switch. R2#ping 2001:aaaa:bbbb:dddd::1 Type escape sequence to abort. R2(config)#ipv6 route 2001:AAAA:BBBB:DDDD::0/64 f0/0 FE80::C003:8FF:FE2F:0 SW1#configure terminal Switch-1#show port-security Switch-1(config-if)#description ‘This is the Management Subnet’ Switch-1(config-if)#ip address 10.30.30.2 255.255.255.0 Pinging 10.10.10.254 with 32 bytes of data: Verifying the correct path selection Because all routers in the network have the same view of the network, the most optimal paths are used for forwarding packets between networks and the possibility of routing loops is eliminated. Therefore, techniques such as split horizon and route poisoning do not apply to Link State routing protocols as they do to Distance Vector routing protocols. Troubleshooting Inter-VLAN Routing Instructions C 131.108.99.0 is directly connected, Serial0 2.6.bLLDP all all VLANs Maximum path: 4 Switch-1(config-if)#switchport port-security maximum 2 Administrative Trunking Encapsulation: dot1q Operational Trunking Encapsulation: dot1q Negotiation of Trunking: On Router>en Router#conf t Switch-1#show port-security interface gi0/2 Port Security : Enabled Port Security Secure Addresses ! lines omitted for brevity Gateway of last resort is not set 3.Set the ports the PCs connect to as access ports (default but do it anyway). The administrative distance is a locally significant value that affects only the local router. This value is not propagated throughout the routing domain. Therefore,300-815 claim, manually adjusting the default administrative distance for a routing source or routing sources on a router affects the preference of routing information sources only on that router. Table 10.