300-810 clica book

300-810 clica book

labels Display labels for IPv4 NLRI specific information Switch-1(config-if)#switchport trunk encapsulation dot1q Switch-1(config-if)#switchport mode trunk Switch(config)#username passhot password cisco Switch(config)# Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP U - Per-user Static route,300-810 clica book, M - MIPv6 R1#ping 2001:AAAA:BBBB:EEEE::1 DHCP Functionality DHCP Operations transport input ssh telnet Configuration Revision 0 　　Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Sending 5, 100-byte ICMP Echos to 2001:AAAA:BBBB:DDDD::1, timeout is 2 seconds: Switch-1(config)#interface GigabitEthernet0/2 Switch-1(config-if)#switchport Your choices as a network administrator are to use dynamic routing protocols on your network or static routing, which is where you manually add each route for your network onto each router. the network. You saw earlier with the debug ip rip output that RIP broadcasts updates and is classful so it has no concept of VLSM, meaning that if you had a 192.168.1.16/26 network, it would advertise it as 192.168.1.0/24. Also, it offers no authentication, making it an easy target for attackers wanting to inject false route updates into the network. 4.Issue a show ip route and check all networks on both routers All switches must be configured with the same VTP domain name if they are to exchange VLAN information, as illustrated in the output below: In DHCP, there is a special field available that helps extend the capabilities of this automatic configuration process. You can put many different configuration options inside this field, which are also present in the DHCP RFC. 1 000c.cea7.f3a0 SecureSticky Gi0/2 - 1 0013.1986.0a20 SecureSticky Gi0/2 - 1 001d.09d4.0238 SecureSticky Gi0/2 - longer show up in the routing table. If the link that connected to 172.16.4.2 went down, that route also would no longer show up in the routing table. That being said, using a different example, as shown in Figure 11.7 below, if the downstream router, Router 3, that is hosting 192.168.2.0/24 stopped working, R1 would continue to forward traffic to the next hop using static routes, because static routes are not aware of whether there are issues further downstream.