300-715 sise

300-715 sise

• 1446 Reviews

Now that you understand network routes from the previous section, it will be relatively easy to learn about host routes. A host route is a route for a single host address. It will always have a /32 subnet mask. As with network routes, the ip route command will create static routes for remote hosts by using a mask of 255.255.255.255. Here is an example: (mins) The following output illustrates how to enable port security on an interface and to configure a static secure MAC address of 001f:3c59:d63b on a switch access port: From the port security interface output that is printed above, we can determine the following: 2.7.cSticky (P) Repeater, (S) Station,300-715 sise, (O) Other Switch#show cdp neighbors detail Device ID: Switch ------------------------------------------------------------------ Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(25)FX, RELEASE SOFTWARE (fc1) 2.7.eViolation actions We have covered a lot of ground so far. Don’t worry about how much is left to learn though. Review the main learning points from switch security, routing concepts, static routing and RIP. One final point is that switch security can be configured on Packet Tracer, but many of the commands and show commands don’t work. Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone Add a Banner Message The shutdown VLAN option is similar to the shutdown option; however, this option shuts down a VLAN instead of the entire switch port. This configuration could be applied to ports that have more than one single VLAN assigned to them, such as a voice VLAN and a data VLAN, as well as to trunk links on the switches. Router0#show cdp neighbors For this lab I simply connected two 2960 switches using a crossover cable on port G0/1. Switch# show interface f0/1 Based on the configuration above, by default, up to 10 addresses will be dynamically learned on interface GigabitEthernet0/2 and will be added to the current switch configuration. When sticky address learning is enabled, MAC addresses learned on each port are automatically saved to the current switch configuration and added to the address table.

Free Download Dumps Demo & Study Tools

Latest CCNP Security 300-715 SISE Dumps

100% guarantee you pass the CCNP 300-715 exam! Are you still confused about the exam? Don't worry！You have already take the first step to success. Just choose us without any worries!