300-635 dcauto

300-635 dcauto

Router#show cdp neighbor detail Device ID: Switch1 The first configuration task when implementing VLAN trunking in Cisco IOS Catalyst switches is to configure the desired interface as a Layer 2 switch port. This is performed by issuing the switchport interface configuration command. FastEthernet0/0 is administratively down, line protocol is down Hardware is Gt96k FE, address is c200.27c8.0000 (bia c200.27c8.0000) MTU 1500 bytes, BW 10000 Kbit/sec, DLY 1000 usec, 6.Set interface to trunk on the left switch. Violation Mode : Shutdown IP address Client-ID/ Lease expiration Type Hardware address/ 192.168.1.2 Mar 02 2014 12:07 AM Automatic 0063.6973.636f.2d63 Router(config)#access-list 1 permit host 172.16.1.1 4.If you wish, permit only VLAN 2 on the trunk link. Router0#show cdp ? Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#hostname SwitchA SwitchA(config-if)#switchport mode trunk limit unnecessary peerings, as shown in Figure 10.10 below. This is done using passive interfaces, which prevents the router from forming routing adjacencies on the specific interface. This functions differently based on the specific routing protocol used but the behavior usually falls within the following two categories: Connect a switch to a router and at least two hosts, one per VLAN. Bindings from all pools not associated with VRF: R1(config-router)#int lo0 Switchport: Enabled Cisco IOS allows the definition of individual static routes using the ip route global configuration command. With this command, you will specify the subnet, the network mask, and the next hop address, that is, the next step in the path toward the destination. In lieu of a next hop address,300-635 dcauto, you may also use the outgoing interface as shown below: PC>ipconfig /all RIP was taken out of the CCNA exam some years ago, much to my chagrin. Even though it’s been around a long time (RIP was first specified in 1988 by RFC 1058), it works perfectly well in small networks. RIPv2 addressed many of the shortfalls in v1, meaning that it is still a viable option for you to consider. Even though RIP was removed from the CCNA syllabus, I still taught it in my classroom sessions and referred to it often in lessons because it provided a great foundation on which to build a strong understanding of routing protocols. It is now back in the syllabus (but only version 2).