300-610 dumps

300-610 dumps

Switch-1(config)#interface FastEthernet0/1 Static Host Routes Switch(config-if)#switchport trunk encapsulation dot1q Switch(config-if)#switchport mode trunk Switch(config-if)#switchport nonegotiate Switch(config-if)#exit Aging Time : 10 mins Codes: C - connected, S - static,300-610 dumps, R - RIP, M - mobile, B - BGP SwitchA#show vlan brief There are many types of delay, all of which affect different types of traffic. In general, delay refers to the length of time required to move a packet from its source to its destination through the internetwork. In Cisco IOS software, the interface delay value is in microseconds (µs). ip route 0.0.0.0 0.0.0.0 The Shortest Path First Algorithm Sticky MAC Addresses 0 As with CDP, leaving LLDP turned on while on any edge devices represents a security risk. We will cover this in the security notes (and the following lab). Test direct connectivity using ping Topology Switch#show cdp neighbors detail Device ID: Switch Today you will learn about the following: 01:29:15: RIP: received v2 update from 172.16.1.2 on Serial0 01:29:15:192.168.2.0/24 via 0.0.0.0 192.168.1.0 Referencing Figure 10.9, the branch offices (Access Layer) are dual-homed to the regional office routers (Distribution Layer). Layers are defined using Cisco design models. Using a hierarchical addressing scheme allows the Distribution Layer routers to advertise a summary route for the branch office subnets to the Core Layer. This protects the Core Layer from the effects of any route flapping between the Distribution and the Access Layer routers, because a summary route will not flap until every last one of the more specific prefixes from which it is derived is removed from the routing table. This increases stability within the area. In addition, the routing table size at the Core Layer is further reduced.