300-610 cisco

300-610 cisco

validate the configuration, as follows: Router(config)#banner ? If you use multiple ip route 0.0.0.0 0.0.0.0 commands to configure a default route, traffic will be load balanced over the multiple routes. EIGRP propagates a route to network 0.0.0.0 if the static route is redistributed into the routing protocol. Aging Type : Absolute SecureStatic Address Aging : Disabled Maximum MAC Addresses 1 Figure 10.6 shows a packet leaving Host X destined for Host Y. Note that the next-hop MAC address belongs to Router A (using proxy ARP); however, the IP address belongs to Host Y. When the frame reaches Router B, the Ethernet header and trailer will be exchanged for the WAN protocol, which you can presume is HDLC here. You need to enter a wildcard mask if you want your ACL to match a subnet or an entire network. For example, if you wanted to match 172.20.1.0 255.255.224.0, you would enter the following: Switch-1(config-if)#switchport mode access Switch-1(config-if)#switchport access vlan 5 Switch-1(config-if)#switchport voice vlan 7 Switch-1(config-if)#switchport port-security Day 7 Tasks Switch-1(config-if)#switchport mode access Switch-1(config-if)#switchport port-security Read today’s theory notes Take today’s exam Complete today’s lab Switch(config-if)#switchport mode ? Router(config)#banner ? 3.Set all passwords to be encrypted with level 7 encryption. Aging Time : 10 mins Utilizing the counting to infinity characteristic, if a destination network is farther than the maximum number of hops allowed for that routing protocol, the network would be considered unreachable. The network entry would therefore not be installed into the IP routing table. Switch#show cdp neighbors Switchport: Enabled Packet Forwarding A “network” as it applies to network routing is a remote subnet that you would like to reach. Some examples may be 10.1.0.0/24, 192.168.0.0/16, or 38.122.188.0/25. Basically, if it’s anything below a /31 subnet, then you ultimately would need to rely on a network route to reach it. 4.Issue a show ip route and check all networks on both routers security is enabled. Global port security configuration parameters can be validated by issuing the show port-security command. The following shows the output printed by this command based on default values: i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 ia - IS-IS inter area, * - candidate default,300-610 cisco, U - per-user static route o - ODR, P - periodic downloaded static route RouterB#show ip route 172.16.1.1 Routing entry for 172.16.1.0/24 (C) DOCSIS Cable Device (W) WLAN Access Point, Although the vast majority of your experience with routing to specific networks will be done using Interior Gateway (routing) Protocols, understanding the basics of how a static network route works will provide you with a solid foundation regardless of the environment you support. Static routing to networks is normally not the preferred method, but the reality is that static routes are still used and they certainly provide an excellent opportunity to understand how routing to networks is carried out.